buy gucci-Canon color machine code 216022602360

00 working code
02 working code
11 machines out of paper
12 machine door is not closed
13 machine cardboard machine is not detected
14 The toner cartridge
16 machine does not lack
17 machine into the next tray
41 machines used paper size or orientation of the paper does not use the computer.
42 I / F: 2 ERRORInterface problem: CENTRO * (parallel) RS232 (serial)
5F-50 machine fuser fuser is damaged or there is no voltage.
5F-50 Service CTL SFT EE fuser may be condensation, caused by moisture or temperature protection Short circuit protection. Canon LBP-730 Fuser more out of this code, temperature control system design or component defects, unstable!
5F-51 did not detect the laser beam, the laser deflection motor may be damaged or not installed cartridge.
5F-51 Service CTL SFT EE abnormal motor speed laser deflection, bearing short of oil or rust may be too much, causing too much friction, the speed slows down.
5F-52 SERVICE M2-0212 chanel handbags shop online, Main motor adverse action, it is estimated the problem itself or the motor drive circuit of the faulty components, especially electrolytic capacitors.
5F-54/55 machine both sides of the exhaust fan failure, stalling or dead.
5F-55 SERVICE 010 possible fault location: DC controller christian louboutin bridal, formatter, main motor - do not print engine to communicate with the motherboard.
5F-55 SERVICE 030-032 030 may be ranked the paper drive motor switch problem or issue.
5F-56 bypass trust touch switch.
98 - count cartridge life is about to expire.
9A MP ILL hand to send the board to put the paper size or orientation is inconsistent with the selected computer.
1G K TONER LOW machine does not detect the black toner.
99 ITB WARNING This code means that the transfer component to life.
EF DRUM CHECK code that cartridge life to count chips.
EE DENSITY ERROR referred to as
E0 Drum Warning This code, when only the life of the drum will remind you to.
40 LINE ERROR inspection steps: 1 buy gucci, Check Print cable connections, check the print line connections; 2, Check the RS-232 (serial) parameters match thecomputer, check whether the RS-232 serial port parameters match with the computer, check whether the printer port open, short, and so on.
5F-4F SERVICE CTL SFT E E estimated the laser beam (laser beam) problem, also to be verified. Power initialization, observe whether the red light on the drum.